Carbon Recycling Technology

CRT Carbon Recycling Technology known as “Ramana Cycle” is a new patented concept and system that addresses current problems faced by energy industries with a single solution Current problems: 1.Renewable energy is only a fraction of total energy generated world-wide. Fossil fuel especially natural gas in the cleanest and most widely accepted fuel for base load power generation. However, it emits CO2 a greenhouse gas causing climate change. 2. Electric and Fuel cell cars can eliminate Carbon emission from our roads, but it will dramatically increase the electricity requirement which cannot be met by renewable energy sources alone. Eventually the electricity demand will have to be met by fossil fuels which will sharply increase CO2 emissions in a short span of time thus exacerbating global warming. 3.Grid connected renewable energy has many problems due to intermittent nature of renewable energy such as synchronicity, electronic interface with HT lines, metering etc. There is at least 22% loss while transmitting renewable energy into the grid creating dispatchability issues. Power is transmitted 24 x 7 on HT lines. Solution: CRT addresses all the above issue with a single solution as described below. CRT synthesizes a synthetic fuel CH4, a Hydrocarbon known as SNG (synthetic natural gas) using Carbon from CO2 emissions of gas based power plants and renewable Hydrogen generated from water using renewable energy sources such as Hydro/solar/wind /biomass/ geothermal etc. Once SNG is generated then it can substitute natural gas currently used in power generation. It means one can generate their own SNG and need not depend on oil and gas industries and use conventional gas turbine and generate base load power and transmit using existing transmission lines. This power can be used by electric as well by Fuel cars. There will be a net Zero Carbon emission.The same system can also supply Hydrogen to Fuel cell cars. CRT can be implemented using existing systems supplied by internationally known companies with proven technologies and systems. There are absolutely no commercial risks whatsoever. These systems can be deployed immediately, and they are commercial ready. Each plant is designed specifically based on the capacity, location and purpose.