Google analytics tag

Friday, November 13, 2026

CRT Trigeneration versus 24/7 Solar PV + BESS

20 MW AI data-centre firm-power comparison | 13 November 2026 Clean Energy and Water Technologies Pty Ltd (CEWT) • Preliminary / Confidential Executive finding The prior CEWT screening comparison indicates that engine-based Carbon Recycling Technology (CRT) trigeneration may offer a lower effective cost of continuous firm electricity service than a fully firmed, oversized solar photovoltaic (PV) plus battery energy storage (BESS) system. The result depends strongly on renewable resource, reliability, equipment prices, hydrogen/renewable inputs and the valuation of cooling and carbon benefits. It should not yet be presented as a validated project tariff or bankable LCOE. Indicative results from the working comparison Configuration Indicative A$/MWh Interpretation Oversized solar PV + BESS 319–496 24/7 firm-delivered electricity screening range CRT trigeneration — gross 253 Before allocating cooling/carbon value CRT trigeneration — adjusted 179 After illustrative cooling and carbon-value allocations Figure 1. Comparative screening estimates. The shaded extension denotes the PV+BESS range; figures are not vendor quotations. Common comparison basis • Reference firm electrical demand: 20 MW, continuous operation (24 hours/day). • Currency: Australian dollars (A$); discount rate: 8% real. • Evaluation period: 25 years; annual delivered electricity in the prior model approximately 170,000 MWh (consistent with 20 MW at roughly 97% annual utilisation). • Compare at the delivered-service boundary, including renewable overbuild, battery cycling, replacement, land, interconnection, auxiliaries, and reliability reserves as applicable. • For CRT, include all external renewable electricity for electrolysis and other loads, fuel and start-up requirements, engine operation, CO₂ capture/recycle, water, heat recovery and maintenance. Engineering and commercial interpretation The distinction is between the low cost of solar generation when sunshine is available and the cost of guaranteed, continuous 24/7 supply. A PV+BESS design must be sized for night-time duty and extended low-solar periods; a credible estimate requires hourly or sub-hourly simulation over multiple weather years and explicit reliability criteria. CRT provides dispatchable engine-based power with potentially useful recovered heat for chilled/hot-water services. However, full-cycle external renewable energy demand, methanation efficiency, captured-carbon balance, and lifecycle emissions must be accounted for. Credit for recovered cooling or carbon outcomes must not be double-counted against electricity revenues. Recommended next verification 1. Reproduce both cases from the original editable model and reconcile each A$/MWh line item. 2. Run hourly dispatch and reliability simulations for the proposed Morwell site, including multi-day low-solar scenarios. 3. Obtain equipment and EPC quotations and verify the CRT carbon/hydrogen mass balance. 4. Publish gross electricity cost and integrated service cost separately; state assumptions for cooling revenue and any carbon credits. Status: internal screening comparison. Cost values are carried forward from the earlier discussion; the underlying detailed financial model was not independently re-audited for this summary

Monday, November 9, 2026

**The Carbon We Count and the World We See**

Across the world, we are building more wind turbines and solar farms. Yet the amount of carbon dioxide in the atmosphere keeps rising. How can both be true? Think of a reservoir. Even if we slow the water flowing in, the level will keep rising as long as more water enters than leaves. Carbon dioxide behaves in much the same way. Land and oceans absorb part of what we release. The rest accumulates. Renewable energy can slow that accumulation by displacing fossil fuels, but the atmosphere responds to the total balance. We must also count the carbon released in building the systems that will replace fossil fuels. A solar panel burns no fuel as it generates electricity, yet making and transporting it takes materials and energy. These *embodied emissions* are generally much smaller, per unit of electricity, than the lifetime emissions of fossil generation. As we expand renewable energy, we can reduce those emissions further by using cleaner power and heat in the factories that make the equipment. This is where I see a role for CRT. With the 1 MW demonstrator, we want to find out whether we can capture carbon dioxide, use hydrogen to turn it into methane, and trace the carbon as the system supplies useful power and cooling. When the methane is burned, its carbon returns to the exhaust as carbon dioxide. How much can we capture again? How much escapes? How much energy does the process use? The measurements will tell us whether the system delivers the same services with lower emissions over its lifetime. Beneath this work lies a question that is deeply personal to me. **The world is seen. But who is the seer?** Quantum physics asks what happens when we measure the world. The question I return to is what it means to be aware of a world at all. I can observe a landscape, a sensation, even a thought about myself. What is it that is aware of them? I want to keep both inquiries open. At the demonstrator, that means following the carbon and being honest about what we can verify. In my own life, it means turning some of the attention I give to the world toward the awareness in which I encounter it.

How cheap solar energy can help defossilise an economy through CRT

Cheap solar electricity offers opportunities beyond replacing fossil-fuel power generation. It can also help replace the fossil carbon used to produce fuels, industrial heat and chemical feedstocks. Carbon Recycling Technology (CRT) could bridge these two opportunities by using low-cost solar energy to convert captured CO₂ back into useful carbon-based products, reducing the need to continually extract fresh coal, oil, and gas. Solar supplies the energy; recycled carbon supplies the material Fossil fuels provide both energy and carbon. Solar electricity can replace the energy directly in many applications, but some industries still need carbon-containing molecules as fuels or raw materials. CRT aims to meet that need by recycling carbon already in use. Rather than releasing CO₂ after a single use and replacing it with newly extracted fossil carbon, the approach captures and converts it into another useful input. Solar energy supplies the energy required for that conversion, including the production of hydrogen where the process requires it. CO₂ is the carbon source; it is not an energy source. The economic opportunity is reduced fossil fuel dependence Where conversion costs are competitive, cheap solar electricity could turn carbon recycling into a practical substitute for purchasing fresh fossil inputs. Each successful recycling cycle can reduce the amount of new fossil carbon required for a given output. Across a plant’s operating life, those savings could accumulate. Replicated across industrial sites, the model could reduce fossil fuel imports, exposure to fuel price volatility and demand for further extraction. The scale of the benefit depends on the complete system: solar electricity costs, conversion efficiency, equipment utilisation, hydrogen requirements, capture costs and carbon losses. Low electricity prices are a powerful advantage, but the delivered product must remain competitive after all these costs are included. Connecting variable solar supply with continuous industry Industrial plants often need continuous operation, while solar generation varies. A viable CRT project therefore needs an operating strategy that connects the two. Depending on the configuration, this could involve flexible conversion equipment, hydrogen or product storage, thermal storage, or complementary electricity supplies. Producing and storing useful molecules during periods of abundant solar generation could help extend solar energy’s role beyond daylight hours. Direct electrification remains valuable wherever it is practical and efficient. CRT’s strongest role is likely to be where industry needs carbon molecules or where recycled fuels offer a workable route to replacing fossil inputs. Measure the benefit across the whole plant The test is straightforward: how much fresh fossil fuel does the integrated system avoid, and how much does it reduce total lifecycle emissions? That assessment must include capture and conversion energy, upstream inputs, leakage, uncaptured emissions and the eventual use of the product. Carbon reused inside a controlled industrial system has a different outcome from fuel sold and burned without recapture. A credible project should demonstrate: • Lower fresh fossil fuel consumption for the same useful output. • Lower lifecycle greenhouse gas emissions. • Competitive production costs. • Reliable operation under realistic energy supply conditions. Scaling towards a defossilised economy Defossilisation means progressively replacing newly extracted fossil resources with other energy and material sources. Cheap solar energy, combined with effective carbon recycling, could support that transition by letting industry reuse carbon while drawing more energy from the sun. This would reduce the flow of additional fossil carbon into the atmosphere. Lowering the existing atmospheric CO₂ concentration also requires global emissions to fall below natural and deliberate removals; recycling alone does not establish that outcome. The opportunity for CRT is to demonstrate that solar-powered carbon reuse can deliver measurable fuel savings, competitive industrial products and lower emissions—then replicate the configurations that work.

Sunday, November 8, 2026

Replicating Nature: The Science of Carbon Circulation

CEWT | Engineering and ESG discussion paper | 8 November 2026 Nature has sustained life through the circulation of carbon among the atmosphere, plants, animals, soil, and oceans. The engineering question is whether industry can replace linear fossil-carbon extraction with carefully measured circular-carbon systems. 1. What Nature does with CO₂ Photosynthesis uses sunlight to convert carbon dioxide and water into energy-rich organic matter. Respiration uses oxygen to release biochemical energy and returns CO₂ and water. Digestion makes food nutrients available; cellular respiration is the primary CO₂-generating energy process. Photosynthesis: 6 CO₂ + 6 H₂O + sunlight → C₆H₁₂O₆ + 6 O₂ Cellular respiration: C₆H₁₂O₆ + 6 O₂ → 6 CO₂ + 6 H₂O + energy Carbon circulates, while energy enters the natural system principally from sunlight. Natural carbon cycling is not perfectly closed; geological storage and exchanges with oceans also matter. 2. Carbon cycling compared with CEWT CRT Figure 1. Conceptual analogy between photosynthesis/respiration and renewable-energy-driven methanation/trigeneration. For CRT, recovered CO₂ reacts with externally produced renewable hydrogen to regenerate methane. Combustion or other oxidation can then release energy, after which CO₂ must be captured again to close the intended carbon loop. Methanation: CO₂ + 4 H₂ → CH₄ + 2 H₂O Methane combustion: CH₄ + 2 O₂ → CO₂ + 2 H₂O 3. What changed with industrialisation? Fossil-fuel extraction transfers carbon stored in geological reservoirs over very long periods into the active atmosphere–ocean–biosphere cycle. Natural sinks absorb a substantial part of anthropogenic CO₂ emissions, but not all; the remaining accumulation increases atmospheric CO₂ and warms the climate through its greenhouse effect. 4. Can CRT stabilise atmospheric CO₂? Stabilising human-induced CO₂ warming requires global net CO₂ emissions to reach approximately zero. Reducing atmospheric CO₂ concentrations requires net removal. CRT may reduce demand for freshly extracted fossil carbon if it uses low-emissions energy, avoids leakage and achieves substantial capture and recycling; it does not by itself guarantee carbon neutrality or atmospheric CO₂ removal. Source of carbon Engineering implication CO₂ from existing exhaust May displace fossil-carbon inputs; residual and upstream emissions still count. CO₂ captured from air Draws on atmospheric carbon; substantial capture energy and cost must be included. 5. ESG by Design, Not by Declaration The meaningful metric is cumulative net greenhouse-gas emissions across the complete lifecycle, including embodied plant emissions, electricity imports, hydrogen production, methane leakage, CO₂ recovery losses, construction and decommissioning. Carbon conservation is not energy conservation: repeated fuel regeneration needs a continual external energy input, and irreversibilities cause losses. 6. CEWT proposition Replicating Nature — From Carbon Extraction to Carbon Circulation Industry can investigate a transition from extracting and releasing geological carbon to recovering and circulating carbon already in productive systems. CEWT’s CRT is one candidate pathway: recover CO₂, produce hydrogen using additional low-emissions power, synthesize reusable fuel, deliver electricity/heat/cooling, and recover the resulting CO₂. The environmental benefit must be demonstrated through complete mass, energy and lifecycle carbon balances, not assumed from the presence of recycling alone. Engineering tests before claiming climate benefit • Quantify all carbon entering, circulating within, and leaving the system boundary. • Measure renewable electricity imported for electrolysis, capture, compression and auxiliaries. • Verify CO₂ capture, methane leakage, recycle purity, conversion and purge losses. • Compare lifecycle emissions and fossil-carbon displacement with a credible reference system. Selected background references IPCC, AR6 Synthesis Report (2023): https://www.ipcc.ch/report/ar6/syr/ IEA, Putting CO₂ to Use (2019): https://www.iea.org/reports/putting-co2-to-use

COP31: Carbon Recycling Should Become the Next ESG Agenda

COP31: Carbon Recycling Should Become the Next ESG Agenda As COP31 begins in Türkiye, I believe we must expand the conversation from carbon emissions to carbon management across the entire industrial lifecycle. Solar panels, batteries, transmission infrastructure, and conventional power plants all carry embodied emissions. Reducing operational emissions is essential, but it is only part of the challenge. Nature demonstrates the importance of carbon circulation. Industry should examine how engineering can apply similar principles. Treat carbon not merely as waste, but as a potential resource that can be recovered, recycled, and reused. At Clean Energy and Water Technologies (CEWT), we are exploring this principle through Carbon Recycling Technology (CRT), integrating CO₂ recovery, hydrogen, methanation, electricity generation and useful heat recovery. The environmental benefit must be established through complete mass and energy balances, lifecycle assessment and independently verified emissions reductions. The next ESG agenda should move beyond declarations towards measurable circular-carbon engineering. Carbon recycling is not a substitute for reducing emissions. It is another pathway that deserves rigorous scientific, engineering, and economic evaluation. ESG by Design, Not by Declaration. #COP31 #CarbonRecycling #CircularEconomy #ESG #Decarbonisation #ChemicalEngineering #CEWT Now Available on Amazon Kindle: