Sunday, December 2, 2012

Which is the best storage technology for Renewable energy?

The share of renewable energy is steadily increasing around the world. But storing such intermittent energy source and utilizing it when needed has been a challenge. In fact energy storage constitutes a significant portion of the cost in any renewable energy technology. Many storage technologies are currently available in the commercial market, but choosing a right type of technology has always been a difficult choice. In this article we will consider four types of storage technologies. The California Energy Commission conducted economic and environmental analyses of four energy storage options for a wind energy project: (1) lead acid batteries, (2) zinc bromine (flow) batteries, (3) a hydrogen electrolyzer and fuel cell storage system, and (4) a hydrogen storage option where the hydrogen was used for fueling hydrogen powered vehicle. Their conclusions were: ”Analysis with NREL’s (National Renewable Energy laboratory) HOMER model showed that, in most cases, energy storage systems were not well utilized until higher levels of wind penetration were modeled (i.e., 18% penetration in Southern California in 2020). In our scenarios, hydrogen storage became more cost-effective than battery storage at higher levels of wind power production, and using the hydrogen to refuel vehicles was more economically attractive than reconverting the hydrogen to electricity. The overall value proposition for energy storage used in conjunction with intermittent renewable power sources depends on multiple factors. Our initial qualitative assessment found the various energy storage systems to be environmentally benign, except for emissions from the manufacture of some battery materials. However, energy storage entails varying economic costs and environmental impacts depending on the specific location and type of generation involved, the energy storage technology used, and the other potential benefits that energy storage systems can provide (e.g., helping to optimize Transmission and distribution systems, local power quality support, potential provision of spinning reserves and grid frequency regulation, etc.)”. Key Assumptions Key assumptions guiding this analysis include the following: • Wind power will expand in California under the statewide RPS program to a level of approximately 10% of total energy provided in 2010 and 20% by 2020, with most of this expansion in Southern California. • Costs of flow battery systems are assumed to decline somewhat through 2020 and costs of hydrogen technologies (electrolyzers, fuel cell systems, and storage systems) are assumed to decline significantly through 2020. • In the case where hydrogen is produced, stored, and then reconverted to electricity using fuel cell systems, we assume that the hydrogen can be safely stored in modified wind turbine towers at relatively low pressure at lower costs than more conventional and higher-pressure storage. • In the case where hydrogen is produced and sold into transportation markets, we assume that there is demand for hydrogen for vehicles in 2010 and 2020, and that the Hydrogen is produced at the refueling station using the electricity produced from wind farms (in other words, we assume that transmission capacity is available for this when needed)? Key Project Findings Key findings from the HOMER model projections and analysis include the following: • Energy storage systems deployed in the context of greater wind power development were not particularly well utilized (based on the availability of “excess” off-peak electricity from wind power), especially in the 2010 time frame (which assumed 10% wind penetration statewide), but were better utilized–up to 1,600 hours of operation per year in some cases–with the greater (20%) wind penetration levels assumed for 2020. • The levelized costs of electricity from these energy storage systems ranged from a low of $0.41 per kWh—or near the marginal cost of generation during peak demand times—to many dollars per kWh (in cases where the storage was not well utilized). This suggests that in order for these systems to be economically attractive, it may be necessary to optimize their output to coincide with peak demand periods, and to identify additional value streams from their use (e.g., transmission and distribution system optimization, provision of power quality and grid ancillary services, etc.) • At low levels of wind penetration (1%–2%), the electrolyzer/fuel cell system was either inoperable or uneconomical (i.e., either no electricity was supplied by the energy storage system or the electricity provided carried a high cost per MWh). • In the 2010 scenarios, the flow battery system delivered the lowest cost per energy stored and delivered. • At higher levels of wind penetration, the hydrogen storage systems became more economical such that with the wind penetration levels in 2020 (18% from Southern California), the hydrogen systems delivered the least costly energy storage. • Projected decreases in capital costs and maintenance requirements along with a more durable fuel cell allowed the electrolyzer/fuel cell to gain a significant cost advantage over the battery systems in 2020. • Sizing the electrolyzer/fuel cell system to match the flow battery system’s relatively high instantaneous power output was found to increase the competitiveness of this system in low energy storage scenarios (2010 and Northern California in 2020), but in scenarios with higher levels of energy storage (Southern California in 2020), the Electrolyzer/fuel cell system sized to match the flow battery output became less competitive. • In our scenarios, the hydrogen production case was more economical than the Electrolyzer/fuel cell case with the same amount of electricity consumed (i.e., hydrogen production delivered greater revenue from hydrogen sales than the electrolyzer/fuel cell avoided the cost of electricity, once the process efficiencies are considered). • Furthermore, the hydrogen production system with a higher-capacity power converter and electrolyzer (sized to match the flow battery converter) was more cost-effective than the lower-capacity system that was sized to match the output of the solid-state battery. This is due to economies of scale found to produce lower-cost hydrogen in all cases. • In general, the energy storage systems themselves are fairly benign from an environmental perspective, with the exception of emissions from the manufacture of certain components (such as nickel, lead, cadmium, and vanadium for batteries). This is particularly true outside of the U.S., where battery plant emissions are less tightly controlled and potential contamination from improper disposal of these and other materials are more likely. The overall value proposition for energy storage systems used in conjunction with intermittent renewable energy systems depends on diverse factors. • The interaction of generation and storage system characteristics and grid and energy resource conditions at a particular location. • The potential use of energy storage for multiple purposes in addition to improving the dependability of intermittent renewable (e.g., peak/off-peak power price arbitrage, helping to optimize the transmission and distribution infrastructure, load-leveling the grid in general, helping to mitigate power quality issues, etc.) • The degree of future progress in improving forecasting techniques and reducing prediction errors for intermittent renewable energy systems • Electricity market design and rules for compensating renewable energy systems for their output Conclusions “This study was intended to compare the characteristics of several technologies for providing Energy storage for utility grids—in a general sense and also specifically for battery and Hydrogen storage systems—in the context of greater wind power development in California. While more detailed site-specific studies will be required to draw firm conclusions, we believe those energy storage systems have relatively limited application potential at present but may become of greater interest over the next several years, particularly for California and other areas that is experiencing significant growth in wind power and other intermittent renewable. Based on this study and others in the technical literature, we see a larger potential need for energy storage system services in the 2015–2020 time frames, when growth in renewable produced electricity is expected to reach levels of 20%–30% of electrical energy supplied. Depending on the success in improved wind forecasting techniques and electricity market designs, the role for energy storage in the modern electricity grids of the future may be significant. We suggest further and more comprehensive assessments of multiple energy storage technologies for comparison purposes, and additional site- and technology-specific project assessments to gain a better sense of the actual value propositions for these technologies in the California energy system. This project has helped to meet program objectives and to benefit California in the Following ways: • Providing environmentally sound electricity. Energy storage systems have the Potential to make environmentally attractive renewable energy systems more competitive by improving their performance and mitigating some of the technical issues associated with renewable energy/utility grid integration. This project has identified the potential costs associated with the use of various energy storage technologies as a step toward understanding the overall value proposition for energy storage as a means to help enable further development of wind power (and potentially other intermittent renewable resources as well). • Providing reliable electricity. The integration of energy storage with renewable energy esources can help to maintain grid stability and adequate reserve margins, thereby contributing to the overall reliability of the electricity grid. This study identified the potential costs of integrating various types of energy storage with wind power, against which the value of greater reliability can be assessed along with other potential benefits. • Providing affordable electricity. Upward pressure on natural gas prices, partly as a function of increased demand, has significantly contributed to higher electricity prices in California and other states. Diversification of electricity supplies with relatively low-cost sources, such as wind power, can provide a hedge against further natural gas price increases. Higher penetration of these other (non-natural-gas-based) electricity sources, Potentially enabled by the use of energy storage, can reduce the risks of future electricity.” (Source: California Energy Commission prepared by University of Berkeley).