How to generate your own Hydrogen?

It is amazing that highly combustible Hydrogen is a constituent of cool water. As long as it remains a part of a water molecule we are able to handle it easily. Water is always in a state of ionization with H+ and OH- ions in a dynamic equilibrium. The electrical conductivity of pure water which is completely free from any other ions is almost zero. In a solid polymer electrolyzer, which is the reverse of Fuel cell, water is decomposed into Hydrogen and Oxygen while passing a Direct current. Electrolyzer is an electrolytic cell similar to battery, containing an Anode, Cathode and Electrolyte. In a solid polymer Electrolyzer, the electrolyte is a polymer membrane. Water is decomposed as shown in the following reaction: At Anode of electrolyzer: H2O-------- 0.5 O2 + 2e + 2H† At Cathode of electrolyzer: 2H† + 2e ------ H2 The purity of water is critical in the above process of electrolysis. In conventional electrolysis, water with addition of potash lye (KOH) acts as an electrolyte. But in the above process there is no need for any addition of lye. Moreover, Hydrogen can be generated at high pressure so that further compression becomes easier. In cases of power generation using Fuel cell, the Hydrogen pressure from Electrolyzer is sufficiently high, obviating the usage of an additional compressor. The electrical conductivity of water increases as the concentration of dissolved salts increases. That is why the conductivity of seawater is much higher than your tapwater.But this salt can be removed by the process of desalination using ‘reverse osmosis’ systems. When you separate pure water and salt water using a semi permeable membrane there is natural tendency for pure water to pass across the membrane to pure water side. This process is called ‘Osmosis’. The process continues till the concentration of water on both side of the membrane becomes equal. Nature does not like disparities between strong and weak and always tend to make both equal. By reversing this principle of osmosis, we can separate salt water into pure water and highly concentrated salt water known as brine. This process is called ‘Reverse osmosis’. We will discuss about this process later. If your tap water is not very hard, say for example, total dissolved solids TDS is around 500ppm (Part per million), then the osmotic pressure is not high, which means you do not need to use a high pressure pump. Higher the TDS level, higher the osmotic pressure and higher the power consumption will be. You can install a reverse osmosis system based on your water analysis. You have to use a pure water with low electrical conductivity less than 1 micro Siemens/cm.The reverse osmosis system can be connected to your tap and store pure water while draining the salt water into the drain. You can use this pure water into an Electrolyzer to generate Hydrogen. The Hydrogen can be stored in a tank made up of Carbon composite materials that can withstand high pressure and approved by regulatory authorities. This article is only to understand how Hydrogen can be generated using your tap water. The actual implementation of the system requires knowledge and experience in installing such a system. But we will release an eBook, a step by step guide to set up your power generation system as well fuelling your Fuel cell car, using Hydrogen. An independent power generation and fuelling system using only solar power and water will soon become a commercial reality because, it is a clean and sustainable solution for all our energy problems. The PV solar industries are already expanding at a faster rate and solar Hydrogen will soon become an ultimate solution.